Environmental Test Chambers , PID / SSR Control Method Thermal
Shock Testing Chamber
PID and SSR Control Method Thermal Shock Testing Chamber is used to
test the bearing extent of the material structures and composite
material in an instant and continuous high temperature and
extremely low temperature environment , that is in the shortest
time to test its thermal expansion and contraction caused by
chemical change or physical harm. Application objects, including
metal, plastic, rubber, electronics ... and other materials can be
used as a basis to improve their products or reference.
PID and SSR Control Method Thermal Shock Testing Chamber
Micro processor, multi function control. To control and monitor the
compressor, the solenoid valve and the heater .
When faults occur, the auto detection and protection function will
activate and will automatically cut off the power, the LCD screen
will shows the fault status.
Appointment function , the equipment can be activate and start for
operation through setting (Year, month, date, hour and minute)
Accumulation operation time provide a record for management and
Setting of the backlite of the LCD can extend the useful life of
Can choose one paragraph of control or the multi-screen process to
increase the convenience of its operation.
Curve drawing function: After setting up the operation parameters
or during the running mode, you can call out the screen to
understand the running situations and conditions.
Program execution can be suspended (HOLD), Jump paragraph (ADV) and
other procedures involved in setting.
Recovery time and test time WAIT function.
Power breakdown recovery function, can select BREAK, COLD, or HOT.
|Model||HD-E703-50 PID and SSR Control Method Thermal Shock Testing Chamber|
|Interal Dimension:||(W×H×D)40×36×35 cm|
|Structure:||Two chambers design(the hot chamber or the cold chamber)|
|Damper device:||Forced air drived damper|
|Interior material:||SUS# Stainless steel plate|
|Exterior material:||SUS# Stainless steel plate|
|Basket material:||SUS# Stainless steel plate|
|Refrigeration:||Cascade refrigeration system|
|Preheating temperature:||above freezing 60.00°C~above freezing200.00°C|
|Precooling temperature:||subzero 10.00°~ subzero 70.00°C|
|H.T. Shocking:||above freezing 60.00°C~above freezing 150.00°C|
|L.T. Shocking:||subzero 10.00°C~subzero 65.00°C|
|Simulated load ic||5.0kg|
|HT IN-Zone||subzero 65.00°C~above freezing 150.00°C/5min|
|LT IN-Zone||above freezing 150.00°C subzero 65.00°C|
|Setting range:||Temperature:subzero 100.00°C~above freezing
|Output mode:||PID and SSR(control method)|
|Power(K.W)||AC380V 50HZ 18KW|
Thermal Shock Chamber_pdf.pdf
The introduction of Haida
Haida products are widely used in paper products, packaging, ink
printing, adhesive tapes, bags, footwear, leather products,
environment, toys, baby products, hardware, electronic products,
plastic products, rubber products and other industries, and are
applicable to all scientific research units, quality inspection
institutions and academic fields. Our products meet UL, ASTM, JIS,
GB,SO, TAPPI, EN, DIN, BS and other domestic and international
Packaging & Shipping:
Simulation Animatronic Customer Triceratops are covered with air
bubble film before put them into the wooden case, which not only
has good shock absorption, impact resistance, heat sealing and also
has the advantages of nontoxic, odorless, moisture corrosion, good
If you face any problems in future during testing process we
promise we will give you a reply within 48 hours and solution
provide within 3 working days. We can offer operation video and
English operation muanual. We can provide video-con.